Home and Garden

Refine Search

What is the best bathroom fan?

When shopping for a bathroom fan, a homeowner needs to choose one with a rating of 0.5 to 1.2 sones or 1.5 to 2.0 sones. Fans with these ratings are quiet. All fans have airflow capacity rating measured in cubic feet per minute (CFM). The buyer needs to know the size of the bathroom to choose the right airflow capacity.

Continue Reading

How do you trim dogwood?

Cutting shrubby varieties of dogwood trees to the ground on a routine basis helps them grow new, colorful stems. This allows removal of the less desirable branches and stems, making room for better-looking stems. Other dogwoods don’t need much pruning aside from looking for dead branches and removing them. Trimming is optional for overgrown dogwoods. Also consider removing low-hanging branches periodically. It is best to prune in late winter and early spring, prior to new growth.

Continue Reading

What is a single pole switch?

A single pole switch is named as such because it controls only one circuit. The most basic type has two contacts it uses to either open or close the circuit in order to allow electricity to either flow or shut off. It comes in different types such as knife, toggle or pushbutton. A single pole switch directly controls devices such as ceiling fans, wall lamps, toys and remotes. When wired to an outlet, it controls the electricity to plug-in devices.

Continue Reading

Why would a Heil furnace make loud noises?

First check the belt connecting the motor to the fan if your furnace is making squealing noises. The noise usually means that the belt has slipped out of position. Slip the belt back in position, or replace if worn. Grinding noises are usually caused by shot bearings. Shut off the furnace and immediately call a qualified furnace repair technician. Do not attempt to replace the bearings unless you are a qualified technician.\nTo get rid of a humming noise, locate the burner compartment of your furnace, and remove the cover. Identify the specific component making the humming noise, and tighten t..

Continue Reading

How do you remove pine tar from clothing?

Pretreat the areaPretreat the pine tar stain by applying a stain remover to the area. This helps to remove the waxy part of the pine tar.Prepare the detergentAdd water to powdered detergent, and mix the two together until a thick paste forms. You can also use liquid detergent.Apply the detergentRub the detergent paste or liquid detergent into the pine tar stain. Allow the detergent to soak into the area for 30 minutes.Scrub the stainCarefully scrub the stained area with a cloth. Avoid scrubbing too vigorously.Rinse the garmentRinse the detergent out of the garment with hot water.Wash the garme..

Continue Reading

How do you keep squirrels out of your garden?

Flood their burrowsIf you're able to find where the squirrels live, you can flood their burrows. Fill a large bucket with water, and dump it into any burrows discovered. Repeat this numerous times. Do this on a regular basis until the squirrels are gone.Annoy themBother the squirrels by using motion lights or commercial devices that make high-frequency sounds. You can also surround the garden with unpleasant repellents, such as garlic or ground hot peppers. Urine from predators can also be an effective deterrent.Scare them with other animalsHaving an outdoor dog or cat can help to drive s..

Continue Reading

How do you grow Miss Huff lantana?

Prepare the planting siteChoose a spot with full sun exposure, and dig a hole that is deep enough so the plant's root ball rests evenly at ground level. It should be wide enough to allow 2 to 3 inches between the roots and the sides of the hole.Plant Miss Huff lantanaPlant Miss Huff lantana at least two weeks after the last frost date in spring. Place the plant in the hole, fill it halfway with soil and add water to remove air pockets around the roots. Once the water is absorbed, straighten the plant and continue filling the hole with soil. Add a stake or support to help the tree's t..

Continue Reading

How do you sharpen electric hedge trimmers?

It is best to sharpen an electric hedge trimmer on a flat surface, such as a table or work bench. Eye protection should be worn to ward off any small pieces of metal that might break loose during filing. It is also a good idea to wear thick gloves. Be sure to unplug the hedge trimmer to avoid any power surges during the project.\nUsing a pair of pliers, remove the bolt screw holding the blades in place on the trimmer. Once the blades have been filed, it is possible to test the sharpness of each blade using a sheet of printer paper. Move the paper along the blade and note whether or not it is e..

Continue Reading

How do you remove pit stains?

Solutions for white shirtsMix together 1/4 cup baking soda along with equal amounts of water and hydrogen peroxide. This is enough to treat a single shirt. Another option would be to mix 2 tablespoons oxygen bleach (for safety reasons, do NOT use chlorine bleach) and 2 tablespoons ammonia. Place a protective cloth over the surface area, and apply the solution onto the stain. After leaving for 30 minutes, use a soft toothbrush to scrub away the residue. Allow white clothing to dry in the sun to maximize the brightness of the fabric.Solutions for darker shirtsFill the washing machine with cold w..

Continue Reading

What liquids glow under black light?

When fluorescent substances are exposed to a black light, they glow. This is because they absorb the ultraviolet light that emits from the black light device and re-emit it. A slight modification in energy occurs, however, which makes the emitted light visible to the human eye. Because of this effect, certain substances appear to glow. Some animals even glow under a black light.\nOther types of liquids that glow under a black light include chlorophyll, laundry detergent and some types of cleaners. Tooth whiteners also often glow under a black light. Because these materials are composed of diff..

Continue Reading
Showing 3251 to 3260 of 10000 (1000 Pages)