Where is the blower motor relay located on a Jeep Wrangler?

The blower motor relay on a Jeep Wrangler is located behind the passenger dashboard. Accessing the relay requires removing the kick panel and part of the passenger dashboard.

Accessing the resistor is a fairly simple process and should take under an hour to complete. The following instructions explain how to safely replace a blower motor relay.

1. Disconnect the battery

Open the hood and disconnect the battery to avoid any accidental shocks.

2. Remove the kick panel

The kick panel is found under the passenger dash board. Loosen and remove the 8 mm bolts that hold it in place.

3. Remove the relay

The relay, also know as a resistor, will be easily visible. Loosen the 8 mm bolts that secure it and unclip the unit from the housing.

4. Replace the unit

Replace the relay and reinstall it. Then reconnect the kick panel.