How can one test a 12-volt battery?

By Forinfos - 22/04/2025 - 0 comments

Check a 12-volt battery by disconnecting it from the device it powers, take an initial reading, charge it and take a second reading after the battery sits. Reconnect the battery, attempt to start the device and take a third reading.

  1. Take the initial reading

    A fully charged 12-volt battery should read 12.66 volts. Any reading below 11.89 volts indicates a fully discharged battery.

  2. Charge the battery

    Connect the battery to a charger, and allow it to charge completely. Allow it to sit for eight hours before testing again.

  3. Reconnect the battery, and test with a load

    Reconnect the battery. Disconnect the ignition wire from the coil. Turn on the key for no more than 15 seconds, and read the meter. If it drops below 9.6 volts, it is bad. Batteries that remain at 9.6 volts or above are good.

Login to Comment

Comments

Be the first to write a comment for this article.

Related Articles

How can you determine the best 12-volt battery for your needs? How long will a 250-watt bulb run on a 12-volt battery? How do you use a 12-volt battery charger? How do you install a 12-volt deep cycle RV battery? How long does it take to charge a 12-volt battery? How do you wire two 12-volt batteries to make 24 volts? How long does it take to charge a 12-volt car battery from flat? How do I wire two 12-volt batteries together? How many watts is 120 volts? How many volts are in a standard car battery?

Trending Articles

What was J.D. Robb's first book series? What power did Medusa have? What is Rogers TV? Did Goldie Hawn and Kurt Russell split up? What is a blazon in poetry? What is DigitalDripped.com? What happened in Pitch Perfect 2? What is "shmoop Fuck Finn"? What were some popular movies of 2014? Who is "Bluebird" Bukowski?