How do you use a Char-Broil grill?

To use a Char-Broil gas grill, turn off the gas valve on the propane tank, turn off all of the grill knobs, attach the tank to the grill, secure the gas lines, hand tighten the nuts and valves and check for leaks. To use a Char-Broil charcoal grill, place charcoals in a mound, squirt a small amount of lighter fluid onto the mound and light the coals.

Run through the following steps to set up and use a Char-Broil gas grill.

1. Turn off the valves and knobs

Turn off the valves on the gas tank by turning them clockwise. Rotate all of the knobs on the grill to the "off" position.

2. Attach the tank to the grill

Different Char-Broil grill models involve different setup instructions. Therefore, users should consult the grill's manual for proper instructions.

3. Remove the seal from the tank

Before removing the seal, make sure it is not damaged.

4. Attach the gas line to the grill

Take the regulator on the gas line and insert it onto the gas tank valve.

5. Tighten the valve

Hand tighten the nut onto the gas tank valve. Tighten all of the parts until they stop completely.

6. Check for leaks

Check for leaks before turning on the grill.

7. Turn on the grill

Turn on the grill to start grilling food.

Run through the following steps to set up and use a Char-Broil charcoal grill.

1. Create a pile of coals

Arrange the coals into a small pile.

2. Add lighter fluid

Add a small amount of lighter fluid to the sides and top of the coals.

3. Light the coals

Carefully light the coals after applying the fluid.

4. Start grilling

Wait around 15 minutes to allow the coals to heat up properly. A coating of gray ash indicates that the coals are ready to use.